The current code uses clrbits_be32 which is incorrect since we are on a little endian machine here. This patch fixes this issue and also removes some unnecessary code: Reading the current GPIO bank state is not required if we are using the SET and CLEAR GPIO registers for setting/clearing bits.

Signed-off-by: Christian Riesch christian.riesch@omicron.at Cc: Nagabhushana Netagunte nagabhushana.netagunte@ti.com Cc: Rajashekhara, Sudhakar sudhakar.raj@ti.com --- Hi, due to lack of hardware I only compile tested this code. I am looking forward to your comments. Regards, Christian

board/davinci/da8xxevm/da850evm.c | 14 +++----------- 1 file changed, 3 insertions(+), 11 deletions(-)

diff --git a/board/davinci/da8xxevm/da850evm.c b/board/davinci/da8xxevm/da850evm.c index 0c7aabb..147013c 100644 --- a/board/davinci/da8xxevm/da850evm.c +++ b/board/davinci/da8xxevm/da850evm.c @@ -335,10 +335,6 @@ int board_early_init_f(void)

int board_init(void) { -#if defined(CONFIG_USE_NOR) || defined(CONFIG_DAVINCI_MMC) - u32 val; -#endif - #ifndef CONFIG_USE_IRQ irq_init(); #endif @@ -378,12 +374,10 @@ int board_init(void)

#ifdef CONFIG_USE_NOR /* Set the GPIO direction as output */ - clrbits_be32((u32 *)GPIO_BANK0_REG_DIR_ADDR, (0x01 << 11)); + clrbits_le32((u32 *)GPIO_BANK0_REG_DIR_ADDR, (0x01 << 11));

/* Set the output as low */ - val = readl(GPIO_BANK0_REG_SET_ADDR); - val |= (0x01 << 11); - writel(val, GPIO_BANK0_REG_CLR_ADDR); + writel(0x01 << 11, GPIO_BANK0_REG_CLR_ADDR); #endif

#ifdef CONFIG_DAVINCI_MMC @@ -391,9 +385,7 @@ int board_init(void) clrbits_le32((u32 *)GPIO_BANK0_REG_DIR_ADDR, (0x01 << 11));

/* Set the output as high */ - val = readl(GPIO_BANK0_REG_SET_ADDR); - val |= (0x01 << 11); - writel(val, GPIO_BANK0_REG_SET_ADDR); + writel(0x01 << 11, GPIO_BANK0_REG_SET_ADDR); #endif

#ifdef CONFIG_DRIVER_TI_EMAC