Currently the ethernet MAC address is read from the 'ethaddr' environment variable into the dev->enetaddr field each time the network hardware is initialized, but it is written to the actual hardware only once at board startup. When 'ethaddr' is set or changed after startup the device can no longer receive packets because the hardware filter is still programmed to the old MAC.

This patch moves the writing of the hardware address from eth_initialize (board startup) to eth_init (just before actually using the network).

Signed-off-by: Ingo van Lil inguin@gmx.de --- net/eth.c | 13 +++++++------ 1 files changed, 7 insertions(+), 6 deletions(-)

diff --git a/net/eth.c b/net/eth.c index 6082c90..2b43ae7 100644 --- a/net/eth.c +++ b/net/eth.c @@ -261,11 +261,6 @@ int eth_initialize(bd_t *bis)

memcpy(dev->enetaddr, env_enetaddr, 6); } - if (dev->write_hwaddr && - !eth_mac_skip(eth_number) && - is_valid_ether_addr(dev->enetaddr)) { - dev->write_hwaddr(dev); - }

eth_number++; dev = dev->next; @@ -347,8 +342,14 @@ int eth_init(bd_t *bis) do { uchar env_enetaddr[6];

- if (eth_getenv_enetaddr_by_index(eth_number, env_enetaddr)) + if (eth_getenv_enetaddr_by_index(eth_number, env_enetaddr)) { memcpy(dev->enetaddr, env_enetaddr, 6); + if (dev->write_hwaddr && + !eth_mac_skip(eth_number) && + is_valid_ether_addr(dev->enetaddr)) { + dev->write_hwaddr(dev); + } + }

++eth_number; dev = dev->next;