With DM enabled, there is no need for board code to initialize the Ethernet interfaces.

Specifically board_interface_eth_init will handle the configuration of GPR1.

Signed-off-by: Tim Harvey tharvey@gateworks.com --- board/gateworks/venice/venice.c | 19 ------------------- 1 file changed, 19 deletions(-)

diff --git a/board/gateworks/venice/venice.c b/board/gateworks/venice/venice.c index 3080ff20cb02..d4c22121497b 100644 --- a/board/gateworks/venice/venice.c +++ b/board/gateworks/venice/venice.c @@ -45,22 +45,6 @@ int board_fit_config_name_match(const char *path) return -1; }

-static int __maybe_unused setup_fec(void) -{ - struct iomuxc_gpr_base_regs *gpr = - (struct iomuxc_gpr_base_regs *)IOMUXC_GPR_BASE_ADDR; - -#ifndef CONFIG_IMX8MP - /* Use 125M anatop REF_CLK1 for ENET1, not from external */ - clrsetbits_le32(&gpr->gpr[1], 0x2000, 0); -#else - /* Enable RGMII TX clk output */ - setbits_le32(&gpr->gpr[1], BIT(22)); -#endif - - return 0; -} - #if (IS_ENABLED(CONFIG_NET)) int board_phy_config(struct phy_device *phydev) { @@ -91,9 +75,6 @@ int board_init(void) { venice_eeprom_init(1);

- if (IS_ENABLED(CONFIG_FEC_MXC)) - setup_fec(); - return 0; }