Hi All, I have a custom board housing MPC852T that has one SMC and 2 SCC controllers.

I am able to configure the SMC for UART functionality. And the SCC4 for serial Ethernet functionality. But if I configure the SCC3 for Ethernet functionality I am losing the Serial prints aswell. Using the BDI I have been able to locate that the execution gets stuck in printf routines.

I have defined the following in "commproc.h" ***************************************************** For SCC3 ------------------------------------------------- #define PROFF_ENET PROFF_SCC3 #define CPM_CR_ENET CPM_CR_CH_SCC3 #define SCC_ENET 2

/* CONFIG_SCC3_ENET */

#define PA_ENET_RXD (ushort)0x0010) /* PA 11 - Rx */ #define PA_ENET_TXD ((ushort)0x0020)/* PA 10 - Tx */ #define PA_ENET_RCLK ((ushort)0x1000 )/* PA 3 - CLK5 */ #define PA_ENET_TCLK ((ushort)0x2000 )/* PA 2 - CLK6 */

#define PC_ENET_RENA ((ushort)0x0200 )/* PC 6 - CD3 */ #define PC_ENET_TENA ((ushort)0x0004 )/* PC 13 - RTS3*/

#define PC_ENET_CLSN ((ushort)0x0100 )/* PC 7 - CTS3 */

#define SICR_ENET_MASK ((uint)0x00FF0000) #define SICR_ENET_CLKRT ((uint)0x00250000)

*************************************************** Warm Regards, Raghu

__________________________________ Do you Yahoo!? Free Pop-Up Blocker - Get it now http://companion.yahoo.com/