From: Ye Li ye.li@nxp.com

The IS_ENABLED, which does not consider SPL build, should be replaced by CONFIG_IS_ENABLED. For the case that we only enable DM CLK for u-boot but not in SPL, the IS_ENABLED(CONFIG_CLK) still returns true, then cause clock failure.

Reviewed-by: Peng Fan peng.fan@nxp.com Signed-off-by: Ye Li ye.li@nxp.com Signed-off-by: Peng Fan peng.fan@nxp.com --- drivers/i2c/imx_lpi2c.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/i2c/imx_lpi2c.c b/drivers/i2c/imx_lpi2c.c index 92c500327b4..ad9293c92e1 100644 --- a/drivers/i2c/imx_lpi2c.c +++ b/drivers/i2c/imx_lpi2c.c @@ -282,7 +282,7 @@ static int bus_i2c_set_bus_speed(struct udevice *bus, int speed) bool mode; int i;

- if (IS_ENABLED(CONFIG_CLK)) { + if (CONFIG_IS_ENABLED(CLK)) { clock_rate = clk_get_rate(&i2c_bus->per_clk); if (clock_rate <= 0) { dev_err(bus, "Failed to get i2c clk: %d\n", clock_rate); @@ -462,7 +462,7 @@ static int imx_lpi2c_probe(struct udevice *bus) return ret; }

- if (IS_ENABLED(CONFIG_CLK)) { + if (CONFIG_IS_ENABLED(CLK)) { ret = clk_get_by_name(bus, "per", &i2c_bus->per_clk); if (ret) { dev_err(bus, "Failed to get per clk\n");