st 16. 11. 2022 v 11:59 odesílatel Michal Simek michal.simek@amd.com napsal:

zcu106 also connects ethernet phy reset via tca6416 chip as is done on other evaluation boards. That's why describe this connection to make sure that ethernet phy is reset before it's use.

Signed-off-by: Michal Simek michal.simek@amd.com

arch/arm/dts/zynqmp-zcu106-revA.dts | 19 +++++++++++++------ 1 file changed, 13 insertions(+), 6 deletions(-)

diff --git a/arch/arm/dts/zynqmp-zcu106-revA.dts b/arch/arm/dts/zynqmp-zcu106-revA.dts index 3e137676feb6..4858b4d1f5e9 100644 --- a/arch/arm/dts/zynqmp-zcu106-revA.dts +++ b/arch/arm/dts/zynqmp-zcu106-revA.dts @@ -200,12 +200,19 @@ phy-mode = "rgmii-id"; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_gem3_default>;

•   phy0: ethernet-phy@c {
  

•           reg = <0xc>;
  

•           ti,rx-internal-delay = <0x8>;
  

•           ti,tx-internal-delay = <0xa>;
  

•           ti,fifo-depth = <0x1>;
  

•           ti,dp83867-rxctrl-strap-quirk;
  

•   mdio: mdio {
  

•           #address-cells = <1>;
  

•           #size-cells = <0>;
  

•           phy0: ethernet-phy@c {
  

•                   #phy-cells = <1>;
  

•                   reg = <0xc>;
  

•                   compatible = "ethernet-phy-id2000.a231";
  

•                   ti,rx-internal-delay = <0x8>;
  

•                   ti,tx-internal-delay = <0xa>;
  

•                   ti,fifo-depth = <0x1>;
  

•                   ti,dp83867-rxctrl-strap-quirk;
  

•                   reset-gpios = <&tca6416_u97 6 GPIO_ACTIVE_LOW>;
  

•           };
    };
  

};

-- 2.36.1

Applied. M