Subject: [PATCH] mmc: fsl_esdhc_imx: fix config check issue when building in SPL

Should use CONFIG_IS_ENABLED not IS_ENABLED for clock and regulator drivers, CONFIG_IS_ENABLED will check the CONFIG_SPL_CLK and CONFIG_SPL_DM_REGULATOR when building SPL.

Signed-off-by: Ye Li ye.li@nxp.com

drivers/mmc/fsl_esdhc_imx.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/mmc/fsl_esdhc_imx.c b/drivers/mmc/fsl_esdhc_imx.c index c0d47ba..4938202 100644 --- a/drivers/mmc/fsl_esdhc_imx.c +++ b/drivers/mmc/fsl_esdhc_imx.c @@ -146,7 +146,7 @@ struct fsl_esdhc_priv { u32 tuning_start_tap; u32 strobe_dll_delay_target; u32 signal_voltage; -#if IS_ENABLED(CONFIG_DM_REGULATOR) +#if CONFIG_IS_ENABLED(DM_REGULATOR) struct udevice *vqmmc_dev; struct udevice *vmmc_dev; #endif @@ -1515,7 +1515,7 @@ static int fsl_esdhc_probe(struct udevice *dev)

init_clk_usdhc(dev->seq);

• if (IS_ENABLED(CONFIG_CLK)) {

• if (CONFIG_IS_ENABLED(CLK)) { /* Assigned clock already set clock */ ret = clk_get_by_name(dev, "per", &priv->per_clk); if (ret) {

Applied to mmc/master.

Thanks, Peng.

-- 2.7.4