[U-Boot-Users] loadb problem
Yesterday I wanted to load a binary over serial port but I can´t. The console is running and I can make input over serial and output is running too.
What could be wrong?
I tried to load binary with TeraTerm and Hyperterminal!? I chose Kermitprotocol! -- View this message in context: http://www.nabble.com/loadb-problem-t1429882.html#a3856501 Sent from the Uboot - Users forum at Nabble.com.
In message 3856501.post@talk.nabble.com you wrote:
Yesterday I wanted to load a binary over serial port but I can=C2=B4t. The = console is running and I can make input over serial and output is running too.
And what exactly is the problem? Are there any error messages or what? What was the exact commands you entered, and what output did you get?
I tried to load binary with TeraTerm and Hyperterminal!? I chose Kermitprotocol!
Try using kermit instead...
Best regards,
Wolfgang Denk
I found the problem! I switched the byteorder in FIFO for my BIG_ENDIAN System!
-- View this message in context: http://www.nabble.com/loadb-problem-t1429882.html#a3859687 Sent from the Uboot - Users forum at Nabble.com.
participants (2)
-
Hurricane555 -
Wolfgang Denk