There are no users of the imx6_pcie_toggle_power and imx6_pcie_toggle_reset weak overrides and as these functions are able to be handled now via dt properties lets remove these.

Cc: Marek Vasut marex@denx.de Signed-off-by: Tim Harvey tharvey@gateworks.com --- arch/arm/include/asm/arch-mx6/sys_proto.h | 3 --- drivers/pci/pcie_imx.c | 10 ++-------- 2 files changed, 2 insertions(+), 11 deletions(-)

diff --git a/arch/arm/include/asm/arch-mx6/sys_proto.h b/arch/arm/include/asm/arch-mx6/sys_proto.h index c7542e4b04e1..7845fa8e5693 100644 --- a/arch/arm/include/asm/arch-mx6/sys_proto.h +++ b/arch/arm/include/asm/arch-mx6/sys_proto.h @@ -18,9 +18,6 @@ #define is_usbotg_phy_active(void) (!(readl(USB_PHY0_BASE_ADDR + USBPHY_PWD) & \ USBPHY_PWD_RXPWDRX))

-int imx6_pcie_toggle_power(struct udevice *vpcie); -int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high); - enum ldo_reg { LDO_ARM, LDO_SOC, diff --git a/drivers/pci/pcie_imx.c b/drivers/pci/pcie_imx.c index f8daedbce359..46ac01713ff7 100644 --- a/drivers/pci/pcie_imx.c +++ b/drivers/pci/pcie_imx.c @@ -532,7 +532,7 @@ static int imx6_pcie_init_phy(void) return 0; }

-__weak int imx6_pcie_toggle_power(struct udevice *vpcie) +int imx6_pcie_toggle_power(struct udevice *vpcie) { #ifdef CONFIG_PCIE_IMX_POWER_GPIO gpio_request(CONFIG_PCIE_IMX_POWER_GPIO, "pcie_power"); @@ -554,7 +554,7 @@ __weak int imx6_pcie_toggle_power(struct udevice *vpcie) return 0; }

-__weak int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high) +int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high) { /* * See 'PCI EXPRESS BASE SPECIFICATION, REV 3.0, SECTION 6.6.1' @@ -570,12 +570,6 @@ __weak int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high) * configuration file and the condition below will handle the rest * of the reset toggling. * - * In case your #PERST toggling logic is more complex, for example - * connected via CPLD or somesuch, you can override this function - * in your board file and implement reset logic as needed. You must - * not forget to wait at least 20 ms after de-asserting #PERST in - * this case either though. - * * In case your #PERST line of the PCIe EP device is not connected * at all, your design is broken and you should fix your design, * otherwise you will observe problems like for example the link