Hi All: I am using MPC8266ADS-PCI board, my board seems crash at "relocate_code:" and reboot again and again. So I can see the boot messages repeatly printed on my console. Any good ideas ? Thanks a lot.

...

...

...

...

...

>>>>>>>>>>>>>>>>>>>>>>>>>>>> MESSAGES DRUING BOOTING, REPEATED

U-Boot 0.4.0 (Jul 10 2003 - 17:37:18)

MPC8260 Reset Status: Check Stop, External Soft, External Hard

MPC8260 Clock Configuration - Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq 25-75 , Core Freq 100-300 - dfbrg 0, corecnf 0x0a, busdf 5, cpmdf 1, plldf 0, pllmf 2 - vco_out 396000000, scc_clk 99000000, brg_clk 99000000 - cpu_clk 264000000, cpm_clk 198000000, bus_clk 66000000

CPU: MPC8260 (Rev 14, Mask A.0(A) 2K25A) at 264 MHz Board: Motorola MPC8266ADS I2C: ready DRAM: SDRAM configuration read from SPD Size per side = 16MB Organization: 1 sides, 2 banks, 9 Columns, 11 Rows, Data width = 64 bits Refresh rate = 33, CAS latency = 3 Total size: 16 MB Top of RAM usable for U-Boot at: 01000000 haha Reserving 190k for U-Boot at: 00fd0000 Reserving 384k for malloc() at: 00f70000 Reserving 76 Bytes for Board Info at: 00f6ffb4 Reserving 68 Bytes for Global Data at: 00f6ff70 Stack Pointer at: 00f6ff58 New Stack Pointer is: 00f6ff58 before memcpy 16187248, -268419200, 68 after memcpy

U-Boot 0.4.0 (Jul 10 2003 - 17:37:18)

MPC8260 Reset Status: Check Stop, External Soft, External Hard

MPC8260 Clock Configuration - Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq 25-75 , Core Freq 100-300 - dfbrg 0, corecnf 0x0a, busdf 5, cpmdf 1, plldf 0, pllmf 2 - vco_out 396000000, scc_clk 99000000, brg_clk 99000000 - cpu_clk 264000000, cpm_clk 198000000, bus_clk 66000000