CONFIG_DM_SPI_FLASH is only supported now with passing of driver conversion deadline from non-DM to DM model. Hence, it's safe to remove non-DM code check from pfe_spi_flash_init.

Also use CONFIG_ENV_SPI_MODE and CONFIG_ENV_SPI_MAX_HZ instead of reading reading values from DT.

Signed-off-by: Kuldeep Singh kuldeep.singh@nxp.com --- drivers/net/pfe_eth/pfe_firmware.c | 16 +++++----------- 1 file changed, 5 insertions(+), 11 deletions(-)

diff --git a/drivers/net/pfe_eth/pfe_firmware.c b/drivers/net/pfe_eth/pfe_firmware.c index 4ad09dd..d414c75 100644 --- a/drivers/net/pfe_eth/pfe_firmware.c +++ b/drivers/net/pfe_eth/pfe_firmware.c @@ -167,26 +167,20 @@ static int pfe_fit_check(void) int pfe_spi_flash_init(void) { struct spi_flash *pfe_flash; + struct udevice *new; int ret = 0; void *addr = malloc(CONFIG_SYS_QE_FMAN_FW_LENGTH);

if (!addr) return -ENOMEM;

-#ifdef CONFIG_DM_SPI_FLASH - struct udevice *new; - - /* speed and mode will be read from DT */ ret = spi_flash_probe_bus_cs(CONFIG_ENV_SPI_BUS, - CONFIG_ENV_SPI_CS, 0, 0, &new); + CONFIG_ENV_SPI_CS, + CONFIG_ENV_SPI_MAX_HZ, + CONFIG_ENV_SPI_MODE, + &new);

pfe_flash = dev_get_uclass_priv(new); -#else - pfe_flash = spi_flash_probe(CONFIG_ENV_SPI_BUS, - CONFIG_ENV_SPI_CS, - CONFIG_ENV_SPI_MAX_HZ, - CONFIG_ENV_SPI_MODE); -#endif if (!pfe_flash) { printf("SF: probe for pfe failed\n"); free(addr);