Hai Everyone,

I am using Powerpc 440GX and u-boot 2014.04 actually i am not understanding the flash configurations actually in my flash total 4 banks and NOR Flash I am using Bank1 8MB 8x8 KByte/4 KWord and 15x64KB/32 KWord Bank2 24MB 48x64KByte/32 KWord Bank3 24MB 48x64KByte/32 KWord Bank4 8MB 8x8 KByte/4 KWord and 15x64KB/32 KWord Those are my Flash Configurations and in my project address is Starts Bank1 FC00 0000 to FC7F FFFF (8Mb) Bank2 FC80 0000 to FDFF FFFF (24Mb) Bank3 FE00 0000 to FF7F FFFF (24Mb) Bank4 FF80 0000 to FFFF FFFF (8Mb)

In project i can use below type or not give me some suggestions static unsigned long flash_addr_table[8][CONFIG_SYS_MAX_FLASH_BANKS] = { {FC00 0000, 0xFC80 0000, 0xFE00 0000, 0xFF800000}, /* 0:000: configuraton 4 */ /* 1:001: configuraton 3 */ /* 2:010: configuraton 8 */ /* 3:011: configuraton 7 */ /* 4:100: configuraton 2 */ /* 5:101: configuraton 1 */ /* 6:110: configuraton 6 */ /* 7:111: configuraton 5 */ }; Why above used different configurations could you give some suggestions

-- View this message in context: http://u-boot.10912.n7.nabble.com/Powerpc-U-Boot-board-amcc-ocotea-flash-c-f... Sent from the U-Boot mailing list archive at Nabble.com.