Hi Adam,

Adam Ford aford173@gmail.com wrote on Thu, 11 Jun 2020 21:49:12 -0500:

I am doing some spot checks on the da850evm which boots from SPI. It seems OK, however, when I run the mtdparts, I expect to see the partition map of the SPI flash.

Unfortunately, I get the following error: nor0: partition (SPL) size alignment incorrect

Currently, it's setup as follows: CONFIG_MTDPARTS_DEFAULT="mtdparts=spi0.0:32k(SPL),480k(u-boot),64k(u-boot-env),7552k(kernel-spare),64k(MAC-Address)"

It's not very clear to me what the error might be but did you consider the fact that the block size could be 64k instead of 32k?

This used to work, but I was hoping someone might have an idea on what I can do to address it. I haven't had a chance to bisect yet.

If you're still testing with the same board, the above proposal is unlikely to fix your issue.

Also, it might be worth adding traces in cmd/mtdparts.c to see whether it is the start (unlikely, would mean there is a serious issue here), or the end of the partition which is the culprit.

Cheers, Miquèl