[U-Boot-Users] eth0 not geting enabled
Hi there
I am working on at91sam9260ek. I have put kernel and rfs on dataflash. Now this board boots up but doesn't enable eth0. I searched net and found that if I do a ping it enables phy (MD9161A). But if I do that when there is no network u-boot never recovers. Can someone tell me the way out. It is successful when network is available, though.
Thanks Avinash
Avinash Vijayvergia wrote:
Hi there
I am working on at91sam9260ek. I have put kernel and rfs on dataflash. Now this board boots up but doesn't enable eth0. I searched net and found that if I do a ping it enables phy (MD9161A). But if I do that when there is no network u-boot never recovers. Can someone tell me the way out. It is successful when network is available, though.
What do you mean by 'u-boot never recovers'? It should time out if you try a network operation and are not connected to anything useful.
regards, Ben
Hi,
On Mon, Jun 2, 2008 at 1:21 PM, Avinash Vijayvergia avinashs36@yahoo.com wrote:
Hi there
<snip>
But if I do that when there is no network u-boot never recovers. Can someone tell > me the way out. It is successful when network is available, though.
Are you using a old (really old) u-boot. This behaviour was observed on u-boot 1.1.2, but when we upgraded to 1.2.0 and above, ping used to timeout.
-- sughosh
participants (3)
-
Avinash Vijayvergia -
Ben Warren -
sughosh ganu