[U-Boot] [PATCH] mx6q: mx6qsabrelite: setup_spi() should be called in board_init to allow use for environment

Signed-off-by: Eric Nelson eric.nelson@boundarydevices.com --- board/freescale/mx6qsabrelite/mx6qsabrelite.c | 8 ++++---- 1 files changed, 4 insertions(+), 4 deletions(-)
diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c b/board/freescale/mx6qsabrelite/mx6qsabrelite.c index db1bea9..7fe2dc9 100644 --- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c +++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c @@ -259,10 +259,6 @@ int board_eth_init(bd_t *bis) if (ret) printf("FEC MXC: %s:failed\n", __func__);
-#ifdef CONFIG_MXC_SPI - setup_spi(); -#endif - return 0; }
@@ -278,6 +274,10 @@ int board_init(void) /* address of boot parameters */ gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
+#ifdef CONFIG_MXC_SPI + setup_spi(); +#endif + return 0; }

On 26/02/2012 23:03, Eric Nelson wrote:
Signed-off-by: Eric Nelson eric.nelson@boundarydevices.com
Applied to u-boot-imx, thanks.
Best regards, Stefano Babic
participants (2)
-
Eric Nelson
-
Stefano Babic