Existing eSPI SPL framework assumes booting from spi-image with boot_format header which contains final u-boot Image offset and size. No such header is present in case of corenet devices like T1040.

So, for corenet deives, SPL bootloader use values provided at compilation time. These values can be defined in board specific config file.

Signed-off-by: Priyanka Jain Priyanka.Jain@freescale.com --- drivers/mtd/spi/fsl_espi_spl.c | 5 +++++ 1 files changed, 5 insertions(+), 0 deletions(-)

diff --git a/drivers/mtd/spi/fsl_espi_spl.c b/drivers/mtd/spi/fsl_espi_spl.c index 6263d8c..e5ac79b 100644 --- a/drivers/mtd/spi/fsl_espi_spl.c +++ b/drivers/mtd/spi/fsl_espi_spl.c @@ -31,6 +31,10 @@ void spi_boot(void) hang(); }

+#ifdef CONFIG_FSL_CORENET + offset = CONFIG_SYS_SPI_FLASH_U_BOOT_OFFS; + code_len = CONFIG_SYS_SPI_FLASH_U_BOOT_SIZE; +#else /* * Load U-Boot image from SPI flash into RAM */ @@ -50,6 +54,7 @@ void spi_boot(void) code_len = *(u32 *)(buf + ESPI_BOOT_IMAGE_SIZE); /* Skip spl code */ code_len = code_len - CONFIG_SPL_MAX_SIZE; +#endif /* copy code to DDR */ spi_flash_read(flash, offset, code_len, (void *)CONFIG_SYS_SPI_FLASH_U_BOOT_DST);