Configuring for caddy2 - Board: vme8349, Options: CADDY2 e1000.c: In function 'e1000_reset_hw': e1000.c:1373:11: warning: variable 'icr' set but not used [-Wunused-but-set-variable] e1000.c: In function 'e1000_phy_init_script': e1000.c:4395:11: warning: variable 'ret_val' set but not used [-Wunused-but-set-variable]

Signed-off-by: Kim Phillips kim.phillips@freescale.com --- drivers/net/e1000.c | 6 ++---- 1 files changed, 2 insertions(+), 4 deletions(-)

diff --git a/drivers/net/e1000.c b/drivers/net/e1000.c index 6eab7b2..3541c4c 100644 --- a/drivers/net/e1000.c +++ b/drivers/net/e1000.c @@ -1370,7 +1370,6 @@ e1000_reset_hw(struct e1000_hw *hw) { uint32_t ctrl; uint32_t ctrl_ext; - uint32_t icr; uint32_t manc; uint32_t pba = 0;

@@ -1443,7 +1442,7 @@ e1000_reset_hw(struct e1000_hw *hw) E1000_WRITE_REG(hw, IMC, 0xffffffff);

/* Clear any pending interrupt events. */ - icr = E1000_READ_REG(hw, ICR); + E1000_READ_REG(hw, ICR);

/* If MWI was previously enabled, reenable it. */ if (hw->mac_type == e1000_82542_rev2_0) { @@ -4392,7 +4391,6 @@ e1000_phy_hw_reset(struct e1000_hw *hw) static void e1000_phy_init_script(struct e1000_hw *hw) { - uint32_t ret_val; uint16_t phy_saved_data; DEBUGFUNC();

@@ -4401,7 +4399,7 @@ e1000_phy_init_script(struct e1000_hw *hw)

/* Save off the current value of register 0x2F5B to be * restored at the end of this routine. */ - ret_val = e1000_read_phy_reg(hw, 0x2F5B, &phy_saved_data); + e1000_read_phy_reg(hw, 0x2F5B, &phy_saved_data);

/* Disabled the PHY transmitter */ e1000_write_phy_reg(hw, 0x2F5B, 0x0003);