Enable SPL DTO support to apply matching SoM specific DTOs to cater for the SoM differences in DH i.MX8MP DHCOM PDK2 configuration. This is already enabled in DH i.MX8MP DHCOM PDK3 configuration so align the two configurations.

Fixes: ad1158c50e0e ("arm64: dts: imx8mp: Switch to DT overlays for i.MX8MP DHCOM SoM") Signed-off-by: Marek Vasut marex@denx.de --- Cc: Fabio Estevam festevam@denx.de Cc: Tom Rini trini@konsulko.com Cc: u-boot@dh-electronics.com Cc: u-boot@lists.denx.de --- configs/imx8mp_dhcom_pdk2_defconfig | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/configs/imx8mp_dhcom_pdk2_defconfig b/configs/imx8mp_dhcom_pdk2_defconfig index e5d74a9bdb2..cbc608dd912 100644 --- a/configs/imx8mp_dhcom_pdk2_defconfig +++ b/configs/imx8mp_dhcom_pdk2_defconfig @@ -15,7 +15,6 @@ CONFIG_DM_GPIO=y CONFIG_DEFAULT_DEVICE_TREE="imx8mp-dhcom-pdk2" CONFIG_SPL_TEXT_BASE=0x920000 CONFIG_TARGET_IMX8MP_DH_DHCOM_PDK2=y -CONFIG_OF_LIBFDT_OVERLAY=y CONFIG_DM_RESET=y CONFIG_SYS_MONITOR_LEN=1048576 CONFIG_SPL_MMC=y @@ -41,6 +40,7 @@ CONFIG_FIT=y CONFIG_FIT_EXTERNAL_OFFSET=0x3000 CONFIG_SPL_LOAD_FIT=y CONFIG_SPL_LOAD_FIT_ADDRESS=0x44000000 +CONFIG_SPL_LOAD_FIT_APPLY_OVERLAY=y CONFIG_SYS_BOOTM_LEN=0x8000000 CONFIG_SUPPORT_RAW_INITRD=y CONFIG_OF_SYSTEM_SETUP=y @@ -66,6 +66,7 @@ CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x4c000000 CONFIG_SPL_SYS_MALLOC_SIZE=0x80000 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x300 +# CONFIG_SPL_FIT_IMAGE_TINY is not set CONFIG_SPL_I2C=y CONFIG_SPL_POWER=y CONFIG_SPL_WATCHDOG=y