On Thu, Jul 02, 2009 at 02:46:17PM +0200, Stefan Bohne wrote:

Hello, everyone,

I have to set up a customized board based on the mpc8536ds which boots from nand flash. I'm new to U-Boot and PowerPCs, but I understand that most of the necessary code is already there in U-Boot and that the mpc8536ds configuration has to be extended to support nand boot. Could you give me some hints as to where to start, which #defines I have to look at or which other board configuration to use as reference?

You may want to look at the u-boot provided by Freescale's BSP for various mpc85xx boards -- I think some of them have boot-from-NAND support, which hasn't been pushed upstream yet. Not sure if mpc8536ds has it, but it may.

Otherwise, you can look at mpc8313erdb, which supports booting from the same NAND controller -- but it's a different chip family, so the init sutff will be different. For example, I believe the BSP 85xx NAND loader puts u-boot into locked L2 cache (allowing the full u-boot to do memory init), which doesn't exist on 8313.

-Scott