Hi all

I've got the following problem: on a system with the Spansion S29WS256N NOR flash the buffered write mode doesn't work. Attempts to use CFG_FLASH_USE_BUFFER_WRITE produce

Writing to Flash... Flash buffer write timeout at address a1ff8000 data 86c686c6Timeout writing to Flash

Interestingly, I can write up to one buffer (32 x 16-bit words) of data correctly at the beginning of a sector, but not the second or any further buffer.

BDI2000 uses the MIRRORX16 flash type for these "MirrorBit" flash chips, but for "newer" ones according to a comment in the bdi2000 manual, one has to use the S29M32X16 type, "because of the used unlock address offset". Which also hints at differences between this and "older" chips.

Studying the datasheets of S29WS-N and S29GL-N indeed there is a difference - but not in unlock offsets, but in the address, where the data length has to be written. In S29GL-N the block length is written at the beginning of the respective erase sector, in S29WS-N - at the write address! And the present mtd driver - in U-Boot and in Linux - indeed writes at the sector start. I've changed the driver to write at the data address - but this didn't change anything. I verified that indeed the addressses are calculated correctly, and I still can write the first block in a sector - but not the second. For example, in a 32KB big sector at 0xa1ff8000 a write

cp.b 0x80800000 0xa1ff8000 0x40

works, but

cp.b 0x80800000 0xa1ff8040 0x40

doesn't. In the latter case the standard procedure is to write the "length - 1", i.e., 31 (in words) to 0xa1ff8000 for all blocks in this sector. I modified the driver to write it to 0xa1ff8040, and it didn't help.

Does anyone know the problem and how shall it be solved?

Thanks Guennadi --- Guennadi Liakhovetski, Ph.D.

DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de