From: "Jens Scharsig (BuS Elektronik)" esw@bus-elektronik.de

There is a debug call in board.c befor serial interface was initialized. This moves the debug code behind serial_initialize call.

Signed-off-by: Jens Scharsig (BuS Elektronik) esw@bus-elektronik.de --- arch/m68k/lib/board.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/m68k/lib/board.c b/arch/m68k/lib/board.c index e934cb6..14722e4 100644 --- a/arch/m68k/lib/board.c +++ b/arch/m68k/lib/board.c @@ -402,14 +402,14 @@ void board_init_r (gd_t *id, ulong dest_addr)

gd->flags |= GD_FLG_RELOC; /* tell others: relocation done */

- debug ("Now running in RAM - U-Boot at: %08lx\n", dest_addr); - WATCHDOG_RESET ();

gd->reloc_off = dest_addr - CONFIG_SYS_MONITOR_BASE;

serial_initialize();

+ debug("Now running in RAM - U-Boot at: %08lx\n", dest_addr); + monitor_flash_len = (ulong)&__init_end - dest_addr;

#if defined(CONFIG_NEEDS_MANUAL_RELOC)