Hello Wolfegang, We are trying to debug an intermittent issue on our system board that after writing 0xff to Boot Release Register (BRR) in a 8 core p4080 system all the CPUs do not get started.We see the following output on the console:

CPU up timeout. CPU up mask is 7f should be ff.

We have tried to check all the CPU registers from bdi telnet terminal, but unable to select any core than core 0.

Do you know what the bdi config file should look like?

Ours is pasted below.

Kallol

[INIT]

;WTLB 0x80000700_0xfe00000a 0x10010000_0xfe00003f ;1/1: fe000000->0_fe000000 16MB -I-G- RWXRWX ;WTLB 0x80000900_0xe000000a 0x10020000_0xe000003f ;1/2: e0000000->0_e0000000 256MB -I-G- RWXRWX

[TARGET]

CPUTYPE P4080 0 0 POWERUP 5000 ;start delay after power-up detected in ms JTAGCLOCK 1 ;use 8 MHz JTAG clock (16 does not work) WAKEUP 1000 MMU XLAT

CPUTYPE P4080 1 0 STARTUP HALT CPUTYPE P4080 2 0 STARTUP HALT CPUTYPE P4080 3 0 STARTUP HALT CPUTYPE P4080 4 0 STARTUP HALT CPUTYPE P4080 5 0 STARTUP HALT CPUTYPE P4080 6 0 STARTUP HALT CPUTYPE P4080 7 0 ;STARTUP RUN STARTUP HALT

[HOST] PROMPT p4080> FILE u-boot.p4080 FORMAT ELF ;LOAD AUTO