From: Fabio Estevam festevam@denx.de

Currently, building imx8qm_dmsse20a1_defconfig leads to the following warning:

aarch64-linux-ld.bfd: invalid origin for memory region .sdram

Fix it by using the same SPL memory layout as done in the imx8mq_evk.

Reported-by: Tom Rini trini@konsulko.com Signed-off-by: Fabio Estevam festevam@denx.de Tested-by: Oliver Graute oliver.graute@kococonnector.com --- configs/imx8qm_dmsse20a1_defconfig | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/configs/imx8qm_dmsse20a1_defconfig b/configs/imx8qm_dmsse20a1_defconfig index 3341b5e447fb..57a5007f9e5b 100644 --- a/configs/imx8qm_dmsse20a1_defconfig +++ b/configs/imx8qm_dmsse20a1_defconfig @@ -16,6 +16,7 @@ CONFIG_SPL_SERIAL=y CONFIG_SPL_DRIVERS_MISC=y CONFIG_ENV_OFFSET=0x80000 CONFIG_ENV_SECT_SIZE=0x20000 +CONFIG_SPL_STACK=0x13e000 CONFIG_SPL=y CONFIG_SYS_LOAD_ADDR=0x80280000 CONFIG_SYS_MEMTEST_START=0xA0000000 @@ -38,11 +39,17 @@ CONFIG_USE_BOOTCOMMAND=y CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; else run netboot; fi; fi; else booti ${loadaddr} - ${fdt_addr}; fi" CONFIG_LOG=y CONFIG_BOARD_EARLY_INIT_F=y -CONFIG_SPL_BSS_START_ADDR=0x00128000 CONFIG_SPL_MAX_SIZE=0x1f000 +CONFIG_SPL_HAS_BSS_LINKER_SECTION=y +CONFIG_SPL_BSS_START_ADDR=0x128000 CONFIG_SPL_BSS_MAX_SIZE=0x1000 CONFIG_SPL_BOARD_INIT=y -CONFIG_SPL_SEPARATE_BSS=y +CONFIG_SPL_SYS_MALLOC_SIMPLE=y +# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set +CONFIG_SYS_SPL_MALLOC=y +CONFIG_HAS_CUSTOM_SPL_MALLOC_START=y +CONFIG_CUSTOM_SYS_SPL_MALLOC_ADDR=0x120000 +CONFIG_SYS_SPL_MALLOC_SIZE=0x3000 CONFIG_SPL_POWER_SUPPORT=y CONFIG_SPL_POWER_DOMAIN=y CONFIG_SPL_WATCHDOG_SUPPORT=y