Le 09/02/2019 à 15:01, Fabio Estevam a écrit :

After the conversion to DM the U-Boot binary is called u-boot-dtb.imx, so fix the README file accordingly.

Signed-off-by: Fabio Estevam festevam@gmail.com

Changes since v1:

• Fix all occurrances

  board/warp7/README | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/board/warp7/README b/board/warp7/README index 60339da543..579bb2de38 100644 --- a/board/warp7/README +++ b/board/warp7/README @@ -17,7 +17,7 @@ $ make mrproper $ make warp7_config

Hi Fabio

Fix typo warp7_config into warp7_defconig

$ make

-This will generate the U-Boot binary called u-boot.imx. +This will generate the U-Boot binary called u-boot-dtb.imx.

Put warp7 board in USB download mode:

@@ -28,11 +28,11 @@ Connect a USB to serial adapter between the host PC and warp7

Connect a USB cable between the OTG warp7 port and the host PC

-Copy u-boot.imx to the imx_usb_loader folder. +Copy u-boot-dtb.imx to the imx_usb_loader folder.

-Load u-boot.imx via USB: +Load u-boot-dtb.imx via USB:

-$ sudo ./imx_usb u-boot.imx +$ sudo ./imx_usb u-boot-dtb.imx

Then U-Boot should start and its messages will appear in the console program.

@@ -46,9 +46,9 @@ Use the default environment variables: Run the DFU command: => dfu 0 mmc 0

-Transfer u-boot.imx that will be flashed into the eMMC: +Transfer u-boot-dtb.imx that will be flashed into the eMMC:

-$ sudo dfu-util -D u-boot.imx -a boot +$ sudo dfu-util -D u-boot-dtb.imx -a boot

Then on the U-Boot prompt the following message should be seen after a successful upgrade: