On 01/11/2018 12:28, Marek Vasut wrote:

On 01/11/2018 08:19 AM, Goldschmidt Simon wrote:

...

This driver has been using printf() including filename since it was added. Convert to using debug() instead.

Signed-off-by: Simon Goldschmidt sgoldschmidt@de.pepperl-fuchs.com

Applied, thanks.

I can't see this one in u-boot-socfpga. Anything wrong here?

Regards, Simon

...

---

drivers/ddr/altera/sequencer.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/ddr/altera/sequencer.c b/drivers/ddr/altera/sequencer.c index 6c6bd90e94..42e87b50d3 100644 --- a/drivers/ddr/altera/sequencer.c +++ b/drivers/ddr/altera/sequencer.c @@ -3534,7 +3534,7 @@ static void debug_mem_calibrate(int pass) u32 debug_info;

  if (pass) {

•         printf("%s: CALIBRATION PASSED\n", __FILE__);
  

•         debug("%s: CALIBRATION PASSED\n", __FILE__);
  
          gbl->fom_in /= 2;
          gbl->fom_out /= 2;
  

@@ -3553,7 +3553,7 @@ static void debug_mem_calibrate(int pass) writel(debug_info, &phy_mgr_cfg->cal_debug_info); writel(PHY_MGR_CAL_SUCCESS, &phy_mgr_cfg->cal_status); } else {

•         printf("%s: CALIBRATION FAILED\n", __FILE__);
  

•         debug("%s: CALIBRATION FAILED\n", __FILE__);
  

<>

...

          debug_info = gbl->error_stage;
          debug_info |= gbl->error_substage << 8;

@@ -3570,7 +3570,7 @@ static void debug_mem_calibrate(int pass) writel(debug_info, &sdr_reg_file->failing_stage); }

• printf("%s: Calibration complete\n", __FILE__);
  

• debug("%s: Calibration complete\n", __FILE__);
  

}

/** @@ -3741,7 +3741,7 @@ int sdram_calibration_full(void)

  initialize_tracking();

• printf("%s: Preparing to start memory calibration\n", __FILE__);
  

• debug("%s: Preparing to start memory calibration\n", __FILE__);
  
  debug("%s:%d\n", __func__, __LINE__);
  debug_cond(DLEVEL >= 1,