OK. Please mark old patches superseded.

York

On 10/15/2014 02:04 AM, Kumar Ashish-B37399 wrote:

Hi York,

Please see the attached mail. Since SPI is not supported by fdt_fixup_mtdparts() same is removed in V2

Regards Ashish

-----Original Message----- From: Sun York-R58495 Sent: Wednesday, October 15, 2014 1:51 AM To: Kumar Ashish-B37399 Cc: Wood Scott-B07421; u-Boot@lists.denx.de Subject: Re: [PATCH] powerpc/BSC9132QDS: Enable creation of dynamic partition for NAND and NOR

On 10/14/2014 01:19 PM, Kumar Ashish-B37399 wrote:

...

Hi York,

Yes, I should superseed/reject the below patches

http://patchwork.ozlabs.org/patch/391991/

I think your v2 patch reduced the size of SPI. Please check before you mark them superseded.

York

...

http://patchwork.ozlabs.org/patch/391990/

Regards Ashish

-----Original Message----- From: Sun York-R58495 Sent: Wednesday, October 15, 2014 1:44 AM To: Kumar Ashish-B37399; u-Boot@lists.denx.de Cc: Wood Scott-B07421 Subject: Re: [PATCH] powerpc/BSC9132QDS: Enable creation of dynamic partition for NAND and NOR

On 10/06/2014 05:54 AM, Ashish Kumar wrote:

...

• fdt_fixup_mtdparts is called from ft_board_setup
• run "mtdparts default" to create NAND, NOR partition on uboot
• Use mtdparts to create partitions dynamically rather than using static partitions in device tree

Signed-off-by: Ashish Kumar Ashish.Kumar@freescale.com

board/freescale/bsc9132qds/bsc9132qds.c | 12 ++++++++++++ include/configs/BSC9132QDS.h | 21 +++++++++++++++++++++ 2 files changed, 33 insertions(+), 0 deletions(-)

diff --git a/board/freescale/bsc9132qds/bsc9132qds.c b/board/freescale/bsc9132qds/bsc9132qds.c index 10580bc..c88838b 100644 --- a/board/freescale/bsc9132qds/bsc9132qds.c +++ b/board/freescale/bsc9132qds/bsc9132qds.c @@ -21,6 +21,9 @@ #include <hwconfig.h> #include <i2c.h> #include <fsl_ddr_sdram.h> +#include <jffs2/load_kernel.h> +#include <mtd_node.h> +#include <flash.h>

#ifdef CONFIG_PCI #include <pci.h> @@ -354,6 +357,12 @@ void fdt_del_node_compat(void *blob, const char *compatible) }

#if defined(CONFIG_OF_BOARD_SETUP) +#ifdef CONFIG_FDT_FIXUP_PARTITIONS +struct node_info nodes[] = {

• { "cfi-flash", MTD_DEV_TYPE_NOR, },
• { "fsl,ifc-nand", MTD_DEV_TYPE_NAND, },

+}; +#endif void ft_board_setup(void *blob, bd_t *bd) { phys_addr_t base; @@ -369,6 +378,9 @@ void ft_board_setup(void *blob, bd_t *bd) #endif

fdt_fixup_memory(blob, (u64)base, (u64)size); +#ifdef CONFIG_FDT_FIXUP_PARTITIONS

• fdt_fixup_mtdparts(blob, nodes, ARRAY_SIZE(nodes)); #endif

  ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR); u32 porbmsr = in_be32(&gur->porbmsr); diff --git

a/include/configs/BSC9132QDS.h b/include/configs/BSC9132QDS.h index aeded6d..da78a19 100644 --- a/include/configs/BSC9132QDS.h +++ b/include/configs/BSC9132QDS.h @@ -630,6 +630,27 @@ combinations. this should be removed later #endif

/*

• • Dynamic MTD Partition support with mtdparts */ #ifndef

+CONFIG_SYS_NO_FLASH #define CONFIG_MTD_DEVICE #define +CONFIG_MTD_PARTITIONS #define CONFIG_CMD_MTDPARTS #define +CONFIG_FLASH_CFI_MTD #define MTDIDS_DEFAULT +"nor0=88000000.nor,nand0=ff800000.flash," +#define MTDPARTS_DEFAULT "mtdparts=88000000.nor:256k(dtb),7m(kernel)," \

• 	"55m(fs),1m(uboot);ff800000.flash:1m(uboot)," \
  

• 	"8m(kernel),512k(dtb),-(fs)"
  

+#endif

Isn't this patch conflict with your earlier patch? http://patchwork.ozlabs.org/patch/391991/

York