When flow id is not marked as valid, sysfw reads the register value to get the range of flow ids that are supported. Then compares the flow range with the U-Boot's host id. This will definitely fail as board configuration doesn't assign the full range to U-Boot's host id. In order to work around this, mark the flow id as valid and pass range as 0.

Signed-off-by: Lokesh Vutla lokeshvutla@ti.com --- drivers/dma/ti/k3-udma.c | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-)

diff --git a/drivers/dma/ti/k3-udma.c b/drivers/dma/ti/k3-udma.c index e587f1fcb2..a0e536ae5e 100644 --- a/drivers/dma/ti/k3-udma.c +++ b/drivers/dma/ti/k3-udma.c @@ -938,7 +938,9 @@ static int udma_alloc_rchan_sci_req(struct udma_chan *uc)

req.valid_params = TI_SCI_MSG_VALUE_RM_UDMAP_CH_FETCH_SIZE_VALID | TI_SCI_MSG_VALUE_RM_UDMAP_CH_CQ_QNUM_VALID | - TI_SCI_MSG_VALUE_RM_UDMAP_CH_CHAN_TYPE_VALID; + TI_SCI_MSG_VALUE_RM_UDMAP_CH_CHAN_TYPE_VALID | + TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_START_VALID | + TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_CNT_VALID; req.nav_id = tisci_rm->tisci_dev_id; req.index = uc->rchan->id; req.rx_chan_type = mode; @@ -954,9 +956,6 @@ static int udma_alloc_rchan_sci_req(struct udma_chan *uc) if (uc->rflow->id != uc->rchan->id && uc->dir != DMA_MEM_TO_MEM) { req.flowid_start = uc->rflow->id; req.flowid_cnt = 1; - req.valid_params |= - TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_START_VALID | - TI_SCI_MSG_VALUE_RM_UDMAP_CH_RX_FLOWID_CNT_VALID; }

ret = tisci_rm->tisci_udmap_ops->rx_ch_cfg(tisci_rm->tisci, &req);