-----Original Message----- From: Billy Tsai billy_tsai@aspeedtech.com Sent: Wednesday, April 13, 2022 1:35 PM To: Ryan Chen ryan_chen@aspeedtech.com; ChiaWei Wang chiawei_wang@aspeedtech.com; BMC-SW BMC-SW@aspeedtech.com; andrew@aj.id.au; Billy Tsai billy_tsai@aspeedtech.com; u-boot@lists.denx.de Subject: [PATCH] gpio: aspeed: Fix incorrect offset of read back register.

The offset of the current read back register is the value of the gpio pin, not the value written for the gpio output. This patch fix it to avoid the other gpio output value controlled by the same register being set incorrectly.

Fixes: 7ad889b0f37a ("gpio: Add Aspeed GPIO driver") Signed-off-by: Billy Tsai billy_tsai@aspeedtech.com

Review-by: ryan_chen ryan_chen@aspeedtech.com

---

drivers/gpio/gpio-aspeed.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-aspeed.c b/drivers/gpio/gpio-aspeed.c index a8a2afcb5c..2c5415c671 100644 --- a/drivers/gpio/gpio-aspeed.c +++ b/drivers/gpio/gpio-aspeed.c @@ -211,7 +211,7 @@ static int aspeed_gpio_direction_output(struct udevice *dev, unsigned int offset struct aspeed_gpio_priv *priv = dev_get_priv(dev); const struct aspeed_gpio_bank *bank = to_bank(offset); u32 dir = readl(bank_reg(priv, bank, reg_dir));

• u32 output = readl(bank_reg(priv, bank, reg_val));

• u32 output = readl(bank_reg(priv, bank, reg_rdata));

  dir |= GPIO_BIT(offset); writel(dir, bank_reg(priv, bank, reg_dir)); @@ -239,7 +239,7 @@

aspeed_gpio_set_value(struct udevice *dev, unsigned int offset, int value) { struct aspeed_gpio_priv *priv = dev_get_priv(dev); const struct aspeed_gpio_bank *bank = to_bank(offset);

• u32 data = readl(bank_reg(priv, bank, reg_val));

• u32 data = readl(bank_reg(priv, bank, reg_rdata));

  if (value) data |= GPIO_BIT(offset);

-- 2.25.1