Hello Guys, I have one clarification related to PXA255 code in U-boot. If in board/pxa255_idp/config.mk TEXT_BASE = 0xa3080000 (this is RAM address in my board)

then because of -Ttext option (in u-boot/config.mk file), in U-boot.map file .text section starts from 0xa3080000 address. So all the symbols like _start, _armboot_start get addresses with respect to 0xa3080000 address only. I am using JFLASH to download the code in FLASH and running the code from FLASH. I am disabling that part of code which relocates the binary from FLASH to RAM. What I don't understand is when in MAP file all the symbols have addresses of RAM then after downloading in FLASH, how code is executing?

Regards Amit Kumar

**************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system. ***INFOSYS******** End of Disclaimer ********INFOSYS***