Re: [U-Boot-Users] eth0 not geting enabled

2 Jun
2008
2 Jun
'08
11:01 p.m.
Hi there
I am working on at91sam9260ek. I have put kernel and rfs on dataflash. Now this board boots up but doesn't enable eth0. I searched net and found that if I do a ping it enables phy (MD9161A). But if I do that when there is no network u-boot never recovers. Can someone tell me the way out. It is successful when network is available, though.
What do you mean by 'u-boot never recovers'? It should time out if you try a network operation and are not connected to anything useful.
I expected the same but it doesn't timeout. It just keeps tryingand I have to reset.
regards Avinash
6184
Age (days ago)
6184
Last active (days ago)
0 comments
1 participants
participants (1)
-
Avinash Vijayvergia