Greetings.

I've been trying to get U-Boot 1.2.0 (the latest available from ftp://ftp.denx.de/pub/u-boot) up and running on our Freescale MPC8560ADS evaluation board. For the most part, it all goes well.

However, the one problem I have encountered is the FCC Ethernet device does not get configured. I am using the sources right from the tarball without any changes.

One other problem I have seen is of I change MPC8560ADS.h to use the TSEC instead of the FCC for Ethernet traffic, the devices are seen but the PHY auto negotiation times out.

Does this sound familiar to anyone?

BTW, if I use the U-Boot sources included with the BSP (1.1.2) the TSEC Ethernet works fine, although I haven't been able to get the FCC Ethernet interface to work.

Thanks in advance.

- Mark

This email message and any attachments are confidential and may contain information which is proprietary to Mintera Corporation. If you are not the intended recipient, please notify Mintera Corporation immediately -- by replying to this message or by sending an email to postmaster@mintera.com -- and destroy all copies of this message and any attachments. Thank you.