Dear Jesus Alvarez

The AT91 Linux kernel patches for versions 2.6.27 or later use a separate atmel_nand.c driver that implements some OOB and ECC options that are not exactly the same as those in the standard kernel NAND driver (nand_base.c , etc.). AT91 based boards can use the CONFIG_MTD_NAND_ATMEL option to enable the atmel_nand driver together with CONFIG_MTD_NAND_ATMEL_ECC_HW, CONFIG_MTD_NAND_ATMEL_ECC_SOFT or CONFIG_MTD_NAND_ATMEL_ECC_NONE for the desired ECC. The OOB layout used by that driver appears to be different.

I have no problem using kernel 2.6.27 and u-boot (1.3.4 and 2009.01) on my at91sam9263ek. The Linux kernel driver uses ECC_HW by default and it does not work with U-boot. As long as I set the kernel driver to use ECC_SOFT, Linux kernel loads the root file system (written by U-boot) and detects bad blocks correctly. And I think the ECC_HW is not implemented in U-boot at91 driver. At least in version 1.3.4, the at91 nand driver just points ECC_HW back to ECC_SOFT instead of using the at91 ECC hardware module.

Could this create the potential for incompatibilities when a NAND filesystem is created by U-Boot for mounting from a Linux kernel using the atmel_nand driver? Are there any kernel config options to avoid to make filesystems initialized with the U-Boot "nand write.jffs2" command fully compatible with the kernel MTD NAND drivers

nand write.jffs2 just means skipping bad blocks when writing to NAND. You should always use it. Without ".jffs2", you will write data to bad blocks. Actually after ver 1.3.4, jffs2 is no longer necessary for "nand write" and bad blocks will be skipped by default.

Derek