This patch has been tested on the mcf54415-based stmark2 board. The eSDHC driver works reliably using DMA mode.

Signed-off-by: Angelo Dureghello angelo@sysam.it --- Changes in v2: - add be to le 32-bit byte swap for ColdFire, - remove HS from host capabilities for ColdFire. --- drivers/mmc/fsl_esdhc.c | 43 ++++++++++++++++++++++++++++++++++++++++- include/fsl_esdhc.h | 1 + 2 files changed, 43 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c index 99e5882866..c972412574 100644 --- a/drivers/mmc/fsl_esdhc.c +++ b/drivers/mmc/fsl_esdhc.c @@ -384,6 +384,25 @@ static void check_and_invalidate_dcache_range invalidate_dcache_range(start, end); }

+#ifdef CONFIG_MCF5441x +/* + * Swaps 32-bit words to little-endian byte order. + */ +static inline void sd_swap_dma_buff(struct mmc_data *data) +{ + int i, size = data->blocksize >> 2; + u32 *buffer = (u32 *)data->dest; + u32 sw; + + while (data->blocks--) { + for (i = 0; i < size; i++) { + sw = __sw32(*buffer); + *buffer++ = sw; + } + } +} +#endif + /* * Sends a command out on the bus. Takes the mmc pointer, * a command pointer, and an optional data pointer. @@ -546,8 +565,12 @@ static int esdhc_send_cmd_common(struct fsl_esdhc_priv *priv, struct mmc *mmc, * cache-fill during the DMA operations such as the * speculative pre-fetching etc. */ - if (data->flags & MMC_DATA_READ) + if (data->flags & MMC_DATA_READ) { check_and_invalidate_dcache_range(cmd, data); +#ifdef CONFIG_MCF5441x + sd_swap_dma_buff(data); +#endif + } #endif }

@@ -1029,8 +1052,12 @@ static int esdhc_init_common(struct fsl_esdhc_priv *priv, struct mmc *mmc) /* Disable the BRR and BWR bits in IRQSTAT */ esdhc_clrbits32(&regs->irqstaten, IRQSTATEN_BRR | IRQSTATEN_BWR);

+#ifdef CONFIG_MCF5441x + esdhc_write32(&regs->proctl, PROCTL_INIT | PROCTL_D3CD); +#else /* Put the PROCTL reg back to the default */ esdhc_write32(&regs->proctl, PROCTL_INIT); +#endif

/* Set timout to the maximum value */ esdhc_clrsetbits32(&regs->sysctl, SYSCTL_TIMEOUT_MASK, 14 << 16); @@ -1138,6 +1165,11 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv, if (ret) return ret;

+#ifdef CONFIG_MCF5441x + /* ColdFire, using SDHC_DATA[3] for card detection */ + esdhc_write32(&regs->proctl, PROCTL_INIT | PROCTL_D3CD); +#endif + #ifndef CONFIG_FSL_USDHC esdhc_setbits32(&regs->sysctl, SYSCTL_PEREN | SYSCTL_HCKEN | SYSCTL_IPGEN | SYSCTL_CKEN); @@ -1162,6 +1194,15 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv, voltage_caps = 0; caps = esdhc_read32(&regs->hostcapblt);

+#ifdef CONFIG_MCF5441x + /* + * MCF5441x RM declares in more points that sdhc clock speed must + * never exceed 25 Mhz. From this, the HS bit needs to be disabled + * from host capabilities. + */ + caps &= ~ESDHC_HOSTCAPBLT_HSS; +#endif + #ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC135 caps = caps & ~(ESDHC_HOSTCAPBLT_SRS | ESDHC_HOSTCAPBLT_VS18 | ESDHC_HOSTCAPBLT_VS30); diff --git a/include/fsl_esdhc.h b/include/fsl_esdhc.h index acd8dd06f8..8dbd5249a7 100644 --- a/include/fsl_esdhc.h +++ b/include/fsl_esdhc.h @@ -106,6 +106,7 @@ #define PROCTL_INIT 0x00000020 #define PROCTL_DTW_4 0x00000002 #define PROCTL_DTW_8 0x00000004 +#define PROCTL_D3CD 0x00000008

#define CMDARG 0x0002e008