Hi everybody,

We're trying to bring up a 100M/1G ethernet interface on a custom T4240 board over SGMII and running into the following errors:

Immediately after board reset: => ping 192.168.1.53 Using FM2@DTSEC6 device FM2@DTSEC6: Tx error FM2@DTSEC6: Rx error ping failed; host 192.168.1.53 is not alive

On any subsequent attempts: => ping 192.168.1.53 Using FM2@DTSEC6 device FM2@DTSEC6: Tx buffer not ready. txbd->status = 0x8800 FM2@DTSEC6: Tx buffer not ready. txbd->status = 0x8800 ping failed; host 192.168.1.53 is not alive

We're running from u-boot 2014.07-rc3. Our custom board ethernet bring-up code is closely based on the code for the t4rdb. The SGMII interface hardware is coming up out of reset (we're seeing the interface toggling at the expected rate) but it looks like u-boot isn't communicating with it properly. There's very little information to go on in the source code related to this error (drivers/net/fm/eth.c, in fm_eth_send). What can cause this problem?

Here are my environment variables related to networking: eth1addr=00:50:C2:72:01:04 eth2addr=00:50:C2:72:01:06 eth3addr=00:50:C2:72:01:08 eth4addr=00:50:C2:72:01:0a eth5addr=00:50:C2:72:01:0c eth6addr=00:50:C2:72:01:0e ethact=FM2@DTSEC6 ethaddr=00:50:C2:72:01:02 ethprime=FM2@DTSEC6 ipaddr=192.168.1.230 netmask=255.255.255.0 gatewayip=192.168.1.11

Thanks for any help you can provide. Let me know if you need more information, Danny Gale daniel.gale@coloradoengineeringinc.com