Re: [U-Boot] fw_printenv can't read the uboot enviroment from NAND
-----Original Message-----
From: Mike Frysinger [mailto:vapier@gentoo.org]
Sent: Thursday, April 05, 2012 1:23 AM
To: u-boot@lists.denx.de
Cc: Bishop, Mark
Subject: Re: [U-Boot] fw_printenv can't read the uboot enviroment from
NAND
might want to figure out why that block is bad in your NAND.
-mike
I have another virgin board and it is doing the same thing.
Would this have anything to do with the device page size (2048 + 64 bytes) or block size (64 pages, 128K + 4K bytes)?
(FYI, I have a broken mailer which is why all the mail headers are no longer intact. The list blocks base64.)
On Thursday 05 April 2012 11:14:47 Bishop, Mark wrote:
From: Mike Frysinger [mailto:vapier@gentoo.org]
might want to figure out why that block is bad in your NAND.
I have another virgin board and it is doing the same thing.
i don't think you've ever mentioned what hardware exactly you're using. SoC/controller/nand flash type would be useful information. i can guess you're running a Blackfin cpu, but that's about all.
Would this have anything to do with the device page size (2048 + 64 bytes) or block size (64 pages, 128K + 4K bytes)?
if the driver was broken, then perhaps :) -mike
participants (2)
-
Bishop, Mark -
Mike Frysinger