From: Sylvain Lemieux slemieux@tycoint.com

Incorporate ECC layout for small page NAND from legacy LPCLinux NXP BSP. The code taken from the legacy patch is: - lpc32xx SLC NAND driver (ECC layout for small page)

This layout is matching the lpc32xx NAND SLC Linux Kernel driver.

Signed-off-by: Sylvain Lemieux slemieux@tycoint.com --- Changes from v6 to v7: * No changes; patch context updated.

Changes from v5 to v6: * Updated comment regarding default OOB layout.

Changes from v4 to v5: * No changes; patch context updated.

Changes from v3 to v4: * No changes.

Changes from v2 to v3: * No changes; patch context updated.

Changes from v1 to v2: * Move ECC layout for small page NAND into a separate patch.

The legacy BSP patch (u-boot-2009.03_lpc32x0-v1.07.patch.tar.bz2) was downloaded from the LPCLinux Web site.

drivers/mtd/nand/lpc32xx_nand_slc.c | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/lpc32xx_nand_slc.c b/drivers/mtd/nand/lpc32xx_nand_slc.c index dbb95d9..2e5f139 100644 --- a/drivers/mtd/nand/lpc32xx_nand_slc.c +++ b/drivers/mtd/nand/lpc32xx_nand_slc.c @@ -75,6 +75,19 @@ struct lpc32xx_nand_slc_regs { #define TAC_R_HOLD(n) (max_t(uint32_t, (n), 0xF) << 4) #define TAC_R_SETUP(n) (max_t(uint32_t, (n), 0xF) << 0)

+/* NAND ECC Layout for small page NAND devices + * Note: For large page devices, the default layouts are used. */ +static struct nand_ecclayout lpc32xx_nand_oob_16 = { + .eccbytes = 6, + .eccpos = {10, 11, 12, 13, 14, 15}, + .oobfree = { + {.offset = 0, + . length = 4}, + {.offset = 6, + . length = 4} + } +}; + #if defined(CONFIG_DMA_LPC32XX) #define ECCSTEPS (CONFIG_SYS_NAND_PAGE_SIZE / CONFIG_SYS_NAND_ECCSIZE)

@@ -563,13 +576,16 @@ int board_nand_init(struct nand_chip *lpc32xx_chip) #endif

/* - * Use default ECC layout, but these values are predefined + * These values are predefined * for both small and large page NAND flash devices. */ lpc32xx_chip->ecc.size = CONFIG_SYS_NAND_ECCSIZE; lpc32xx_chip->ecc.bytes = CONFIG_SYS_NAND_ECCBYTES; lpc32xx_chip->ecc.strength = 1;

+ if (CONFIG_SYS_NAND_PAGE_SIZE != NAND_LARGE_BLOCK_PAGE_SIZE) + lpc32xx_chip->ecc.layout = &lpc32xx_nand_oob_16; + #if defined(CONFIG_SYS_NAND_USE_FLASH_BBT) lpc32xx_chip->bbt_options |= NAND_BBT_USE_FLASH; #endif