DMM_LISA_MAP registers program whether memory is mapped on particular EMIF or not. Irrespective of these registers EMIF is getting configured. Correcting the same.

Signed-off-by: Lokesh Vutla lokeshvutla@ti.com --- arch/arm/cpu/armv7/omap-common/emif-common.c | 41 ++++++++++++++++++++++---- 1 file changed, 36 insertions(+), 5 deletions(-)

diff --git a/arch/arm/cpu/armv7/omap-common/emif-common.c b/arch/arm/cpu/armv7/omap-common/emif-common.c index 30dcf1b..88253cf 100644 --- a/arch/arm/cpu/armv7/omap-common/emif-common.c +++ b/arch/arm/cpu/armv7/omap-common/emif-common.c @@ -33,6 +33,8 @@ #include <asm/utils.h> #include <linux/compiler.h>

+static int emif1_enabled = -1, emif2_enabled = -1; + void set_lpmode_selfrefresh(u32 base) { struct emif_reg_struct *emif = (struct emif_reg_struct *)base; @@ -1109,6 +1111,7 @@ void emif_post_init_config(u32 base) void dmm_init(u32 base) { const struct dmm_lisa_map_regs *lisa_map_regs; + u32 i, section, valid;

#ifdef CONFIG_SYS_EMIF_PRECALCULATED_TIMING_REGS emif_get_dmm_regs(&lisa_map_regs); @@ -1216,6 +1219,29 @@ void dmm_init(u32 base) writel(lisa_map_regs->dmm_lisa_map_0, &hw_lisa_map_regs->dmm_lisa_map_0); } + + /* + * EMIF should be configured only when + * memory is mapped on it. Using emif1_enabled + * and emif2_enabled variables for this. + */ + emif1_enabled = 0; + emif2_enabled = 0; + for (i = 0; i < 4; i++) { + section = __raw_readl(DMM_BASE + i*4); + valid = (section & EMIF_SDRC_MAP_MASK) >> + (EMIF_SDRC_MAP_SHIFT); + if (valid == 3) { + emif1_enabled = 1; + emif2_enabled = 1; + break; + } else if (valid == 1) { + emif1_enabled = 1; + } else if (valid == 2) { + emif2_enabled = 1; + } + } + }

/* @@ -1255,15 +1281,20 @@ void sdram_init(void) writel(CM_DLL_CTRL_NO_OVERRIDE, &prcm->cm_dll_ctrl); }

- do_sdram_init(EMIF1_BASE); - do_sdram_init(EMIF2_BASE); - if (!in_sdram) dmm_init(DMM_BASE);

+ if (emif1_enabled) + do_sdram_init(EMIF1_BASE); + + if (emif2_enabled) + do_sdram_init(EMIF2_BASE); + if (!(in_sdram || warm_reset())) { - emif_post_init_config(EMIF1_BASE); - emif_post_init_config(EMIF2_BASE); + if (emif1_enabled) + emif_post_init_config(EMIF1_BASE); + if (emif2_enabled) + emif_post_init_config(EMIF2_BASE); }

/* for the shadow registers to take effect */