[U-Boot] U-Boot bootup process
Hello there,
I'm very new to U-Boot. I'm programming an AMCC PPC440EP (Yosemite) board that will run LynxOS.
Would anyone help me with U-Boot bootup process? On power up, where U-Boot starts executing from and what's the flow of it? What functions it calls? I need to understand the whole picture, like what gets initialized when!
Any kind of information/block-diagram would greatly be appreciated.
Thanks,
Muzammal
Dear Ahmed,
In message 14CFFCE3B2DB2C4C87042A4EFCFD09CB03F0EE3E@BRZ248 you wrote:
Would anyone help me with U-Boot bootup process? On power up, where U-Boot starts executing from and what's the flow of it? What functions it calls? I need to understand the whole picture, like what gets initialized when!
It makes little sense to ask the very same question both through our commercial support system and here on the mailing list.
I will not answer this again.
Wolfgang Denk
participants (2)
-
Ahmed, Muzammal -
Wolfgang Denk