Hi,

On 30 June 2016 at 12:40, Gardner, Austin (GE Transportation) austin.gardner@ge.com wrote:

Still hoping for a response. I have not had any luck trying to get this up and running. Any advice would be very helpful.

Do you have any debug facilities? Maybe a BDI2000? It could be a board fault or something wrong with text base, etc.

Thanks, Austin

From: Gardner, Austin (GE Transportation) Sent: Friday, June 17, 2016 8:57 AM To: 'u-boot@lists.denx.de' u-boot@lists.denx.de Subject: MPC8347 Initial Boot problems

Hello,

I am currently trying to get my MPC8347EA board up and running by porting the MPC8349EMDS configuration that is currently available. This is my first time working with uboot, so naturally I am having some issues. My issue is that I can't get any response from the board after we flash it with the binary image. I don't know if I am flashing it in the wrong location, or if it is because the configurations in the header files that I changed are wrong. I have tried flashing it in various locations such as start of memory, CONFIG_SYS_TEXT_BASE location (changed to our needs of 0xFF8000000), etc. I also have changed a lot of the memory configurations from the MPC8349EMDS such as the timing configs, ddrlawbar and ddrlawar, sdram configs and modes, etc.

After getting the uboot to actually launch to a command line, the next step will be to have it launch to our QNX os.

Any help with this would be greatly appreciated. I apologize if I use the wrong terminology at any point, I am still very new to this.

Thanks, Austin

Regards, Simon