Tested on the following baseline (note "dirty" since I enabled ALT_BOOT in the config in order to use the alternate boot bank.)

Everything seems to work fine with no additional changes. The banner warning message is now gone.

---

U-Boot 2014.10-rc1-00075-ge49f14af1349-dirty (Aug 14 2014 - 10:26:15)

CPU: 8548E, Version: 2.1, (0x80390021) Core: e500, Version: 2.2, (0x80210022) Clock Configuration: CPU0:990 MHz, CCB:396 MHz, DDR:198 MHz (396 MT/s data rate), LBC:99 MHz L1: D-cache 32 KiB enabled I-cache 32 KiB enabled I2C: ready DRAM: Detected UDIMM SDRAM: 128 MiB 256 MiB (DDR2, 64-bit, CL=3, ECC off) Flash: 72 MiB L2: 512 KiB enabled *** Warning - bad CRC, using default environment

PCI: Host, 64 bit, 66 MHz, sync, arbiter 00:01.0 - 8086:1026 - Network controller PCI1: Bus 00 - 00

PCIe1: Root Complex, x1 gen1, regs @ 0xe000a000 02:00.0 - 1148:9e00 - Network controller PCIe1: Bus 01 - 02 In: serial Out: serial Err: serial Net: eTSEC0 [PRIME], eTSEC1 Hit any key to stop autoboot: 0 => ver

U-Boot 2014.10-rc1-00075-ge49f14af1349-dirty (Aug 14 2014 - 10:26:15) powerpc-linux-gcc (GCC) 4.5.2 GNU ld (GNU Binutils) 2.21 =>

---

Signed-off-by: Paul Gortmaker paul.gortmaker@windriver.com --- include/configs/sbc8548.h | 2 ++ 1 file changed, 2 insertions(+)

diff --git a/include/configs/sbc8548.h b/include/configs/sbc8548.h index f28f350fcc86..aee0d9e27309 100644 --- a/include/configs/sbc8548.h +++ b/include/configs/sbc8548.h @@ -13,6 +13,8 @@ #ifndef __CONFIG_H #define __CONFIG_H

+#define CONFIG_SYS_GENERIC_BOARD + /* * Top level Makefile configuration choices */