Hi All..

I have a problem in Accessing LBC Peripheral [CPLD] connected thru LCS7 in MPC8540 based board.

In such case I can get a pulse in the LCS 7 when I use UPM Mode.

But when I use GPCM Mode I couldnt get any pulse..

If anyone knows the answer please pass it on to me.

The steps followed for Accessing the CPLD(LCS 7) in GPCM Mode are as follows ================================================================= #define CFG_BR7_PRELIM 0xf8000801 #define CFG_OR7_PRELIM 0xffff0ee6 [Detailed BR7/OR7 Setting I have explained below]

I tried accessing the device [CPLD Control Register [Offset 0]] as below

void cpldconfig( ) { volatile immap_t *immap = (immap_t *)CFG_IMMR; volatile ccsr_lbc_t *memctl = &immap->im_lbc; volatile ushort *dummy = (uchar *)CFG_CPLD_BASE; /* set all BA bits */ short x; x = *dummy;

}

================================================================= We Configured BR7/OR7 as follows

#define CFG_CPLD_BASE 0xF8000000 #define CFG_CPLD_SIZE 0x00010000 /*64 Kbytes */

#define BRx_PS_8 0x00000800 /* 8 bit port size */ #define BRx_MS_GPCM_P 0x00000000 /* G.P.C.M. Bus Machine Select*/ #define BRx_V 0x00000001 /* Bank Valid */

#define ORxG_SCY_14_CLK 0x000000e0 /* 14 clock cycles wait states */ #define ORxG_CSNT 0x00000800 /* Chip Select Negation Time */ #define ORxG_ACS_DIV2 0x00000600 /* CS is output 1/2 a clock later */ #define ORxG_TRLX 0x00000004 /* Timing Relaxed */ #define ORxG_EHTR 0x00000002 /* Extended Hold Time on Read */ ================================================================= /* * BR7 is configured as follows: * * - Base address of 0xF8000000 * - 8 bit port size * - Data errors checking is disabled * - Read and write access * - GPCM * - Access are handled by the memory controller according to MSEL * - Not used for atomic operations * - No data pipelining is done * - Valid */

# define CFG_BR7_PRELIM ((CFG_CPLD_BASE & BRx_BA_MSK) |\ BRx_PS_8 |\ BRx_MS_GPCM_P |\ BRx_V) ================================================================= /* OR7 is configured as follows: * * - 64 KB byte * - *BCTL0 is asserted upon access to the current memory bank * - *CW / *WE are negated a quarter of a clock earlier * - *CS is output at the same time as the address lines * - Uses a clock cycle length of 15 * - *PSDVAL is generated internally by the memory controller * unless *GTA is asserted earlier externally. * - Relaxed timing is generated by the GPCM for accesses * initiated to this memory region. * - One idle clock is inserted between a read access from the * current bank and the next access. */ #define P2SZ_TO_AM(s) ((~((s) - 1)) & 0xffff8000) /* must be pow of 2 */

# define CFG_OR7_PRELIM (P2SZ_TO_AM(CFG_CPLD_SIZE) |\ ORxG_CSNT |\ ORxG_ACS_DIV2 |\ ORxG_SCY_14_CLK |\ ORxG_TRLX |\ ORxG_EHTR)

=================================================================