[U-Boot-Users] MPC8266 Abatron config file
Does anyone have a configuration file which works with u=boot? I have a file which is good enough to communicate with the board and program the flash. However when I try to run u-boot (type go), the baud rate is not correct. It appears that it is 4X the configured rate. If I remove the Abatron and boot normally, everything works fine.
TIA
In message 200312021130.26182.acurtis@onz.com you wrote:
Does anyone have a configuration file which works with u=boot? I have a file which is good enough to communicate with the board and program the flash. However when I try to run u-boot (type go), the baud rate is not correct. It appears that it is 4X the configured rate. If I remove the Abatron and boot normally, everything works fine.
Well, this is a setting which is definitely hardware (board) depen- dend. So if you don't give away any facts about your hardware it is impossible to help (actually it's probably impossible in general as this might be a custom board).
Best regards,
Wolfgang Denk
This is a standard ADS8266 board. The MPC8266 configuration file I am using has been posted to this list, although I do not see it on your FTP site. Essentially it is the same at the MPC8260 version that is on the site.
On Tuesday 02 December 2003 12:13 pm, Wolfgang Denk wrote:
In message 200312021130.26182.acurtis@onz.com you wrote:
Does anyone have a configuration file which works with u=boot? I have a file which is good enough to communicate with the board and program the flash. However when I try to run u-boot (type go), the baud rate is not correct. It appears that it is 4X the configured rate. If I remove the Abatron and boot normally, everything works fine.
Well, this is a setting which is definitely hardware (board) depen- dend. So if you don't give away any facts about your hardware it is impossible to help (actually it's probably impossible in general as this might be a custom board).
Best regards,
Wolfgang Denk
participants (2)
-
Allen Curtis -
Wolfgang Denk