To deal with a reoccurring problem properly we need to specify addresses for the Linux kernel, Flatted Device Tree and ramdisk that obey the constraints within the kernel's Documentation/arm/Booting file but also make sure that we relocate things within a valid address range.

It is possible with these addresses to also set fdt_high and initrd_high to the value of 0xffffffff. We don't do this by default to allow for the most likely success of people using custom addresses however.

Signed-off-by: Tom Rini trini@ti.com

--- Changes in v2: - Change to 256MB as this is a must-use uppper value rather than a limit compared with known memory size, so was failing on some platforms. We only use this stanza on platforms we know have more than 256MB memory. --- include/configs/am335x_evm.h | 5 +---- include/configs/am43xx_evm.h | 5 +---- include/configs/ti_armv7_common.h | 22 +++++++++++++++++++++- include/configs/ti_omap4_common.h | 4 +--- include/configs/ti_omap5_common.h | 5 +---- 5 files changed, 25 insertions(+), 16 deletions(-)

diff --git a/include/configs/am335x_evm.h b/include/configs/am335x_evm.h index 884a42b..9064ed1 100644 --- a/include/configs/am335x_evm.h +++ b/include/configs/am335x_evm.h @@ -61,11 +61,8 @@

#ifndef CONFIG_SPL_BUILD #define CONFIG_EXTRA_ENV_SETTINGS \ - "loadaddr=0x80200000\0" \ - "fdtaddr=0x80F80000\0" \ - "fdt_high=0xffffffff\0" \ + DEFAULT_LINUX_BOOT_ENV \ "boot_fdt=try\0" \ - "rdaddr=0x81000000\0" \ "bootpart=0:2\0" \ "bootdir=/boot\0" \ "bootfile=zImage\0" \ diff --git a/include/configs/am43xx_evm.h b/include/configs/am43xx_evm.h index 614857d..27777c5 100644 --- a/include/configs/am43xx_evm.h +++ b/include/configs/am43xx_evm.h @@ -112,10 +112,7 @@

#ifndef CONFIG_SPL_BUILD #define CONFIG_EXTRA_ENV_SETTINGS \ - "loadaddr=0x80200000\0" \ - "fdtaddr=0x80F80000\0" \ - "fdt_high=0xffffffff\0" \ - "rdaddr=0x81000000\0" \ + DEFAULT_LINUX_BOOT_ENV \ "fdtfile=undefined\0" \ "bootpart=0:2\0" \ "bootdir=/boot\0" \ diff --git a/include/configs/ti_armv7_common.h b/include/configs/ti_armv7_common.h index 69d69a5..9feec1a 100644 --- a/include/configs/ti_armv7_common.h +++ b/include/configs/ti_armv7_common.h @@ -36,8 +36,28 @@ /* * Our DDR memory always starts at 0x80000000 and U-Boot shall have * relocated itself to higher in memory by the time this value is used. + * However, set this to a 32MB offset to allow for easier Linux kernel + * booting as the default is often used as the kernel load address. */ -#define CONFIG_SYS_LOAD_ADDR 0x80000000 +#define CONFIG_SYS_LOAD_ADDR 0x82000000 + +/* + * We setup defaults based on constraints from the Linux kernel, which should + * also be safe elsewhere. We have the default load at 32MB into DDR (for + * the kernel), FDT above 128MB (the maximum location for the end of the + * kernel), and the ramdisk 512KB above that (allowing for hopefully never + * seen large trees). We say all of this must be within the first 256MB + * as that will normally be within the kernel lowmem and thus visible via + * bootm_size and we only run on platforms with 256MB or more of memory. + */ +#define DEFAULT_LINUX_BOOT_ENV \ + "loadaddr=0x82000000\0" \ + "kernel_addr_r=0x82000000\0" \ + "fdtaddr=0x88000000\0" \ + "fdt_addr_r=0x88000000\0" \ + "rdaddr=0x88080000\0" \ + "ramdisk_addr_r=0x88080000\0" \ + "bootm_size=0x10000000\0"

/* * Default to a quick boot delay. diff --git a/include/configs/ti_omap4_common.h b/include/configs/ti_omap4_common.h index bcb5eab..387f570 100644 --- a/include/configs/ti_omap4_common.h +++ b/include/configs/ti_omap4_common.h @@ -87,10 +87,8 @@ * Environment setup */ #define CONFIG_EXTRA_ENV_SETTINGS \ - "loadaddr=0x82000000\0" \ + DEFAULT_LINUX_BOOT_ENV \ "console=ttyO2,115200n8\0" \ - "fdt_high=0xffffffff\0" \ - "fdtaddr=0x80f80000\0" \ "fdtfile=undefined\0" \ "bootpart=0:2\0" \ "bootdir=/boot\0" \ diff --git a/include/configs/ti_omap5_common.h b/include/configs/ti_omap5_common.h index 7b10fbd..2443d55 100644 --- a/include/configs/ti_omap5_common.h +++ b/include/configs/ti_omap5_common.h @@ -70,10 +70,7 @@ #endif

#define CONFIG_EXTRA_ENV_SETTINGS \ - "loadaddr=0x80200000\0" \ - "fdtaddr=0x80F80000\0" \ - "fdt_high=0xffffffff\0" \ - "rdaddr=0x81000000\0" \ + DEFAULT_LINUX_BOOT_ENV \ "console=" CONSOLEDEV ",115200n8\0" \ "fdtfile=undefined\0" \ "bootpart=0:2\0" \