Hello,

I am having a board with MCF5485 Coldfire processor. I cannot save the parameters in uboot. Whether Uboot support STM28W160C NOR flash.

I having a error shown below while saving the uboot parameters.

-> save Saving Environment to Flash... . done Un-Protected 1 sectors Erasing Flash... . done Erased 1 sectors Writing to Flash... Flash not Erased . done Protected 1 sectors

U-Boot 2010.06-rc2 (Oct 26 2010 - 13:23:00)

CPU: Freescale MCF5485 CPU CLK 200 MHz BUS CLK 100 MHz Board: Freescale FireEngine 5485 EVB I2C: ready DRAM: 64 MiB FLASH: 18 MiB *** Warning - bad CRC, using default environment

In: serial Out: serial Err: serial Net: FEC0, FEC1

regards, Sudeep