Only install der 4xx-EMAC interrupt handlers *after* the core network driver is registered.

This problem was noticed on the APM Taishan 440GX board, where the board hung upon bootup after displaying "Net:".

Signed-off-by: Stefan Roese sr@denx.de --- drivers/net/4xx_enet.c | 14 +++++++------- 1 files changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/net/4xx_enet.c b/drivers/net/4xx_enet.c index b1763b1..f328574 100644 --- a/drivers/net/4xx_enet.c +++ b/drivers/net/4xx_enet.c @@ -2035,6 +2035,13 @@ int ppc_4xx_eth_initialize (bd_t * bis) dev->send = ppc_4xx_eth_send; dev->recv = ppc_4xx_eth_rx;

+ eth_register(dev); + +#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII) + miiphy_register(dev->name, + emac4xx_miiphy_read, emac4xx_miiphy_write); +#endif + if (0 == virgin) { /* set the MAL IER ??? names may change with new spec ??? */ #if defined(CONFIG_440SPE) || \ @@ -2072,13 +2079,6 @@ int ppc_4xx_eth_initialize (bd_t * bis) dev); virgin = 1; } - - eth_register (dev); - -#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII) - miiphy_register (dev->name, - emac4xx_miiphy_read, emac4xx_miiphy_write); -#endif } /* end for each supported device */

return 0;