SH7734 support GMII. This add register infomation and the function which enable GMII.

Signed-off-by: Nobuhiro Iwamatsu nobuhiro.iwamatsu.yj@renesas.com --- V2: Remove debug code

drivers/net/sh_eth.c | 11 ++++++++++- drivers/net/sh_eth.h | 1 + 2 files changed, 11 insertions(+), 1 deletion(-)

diff --git a/drivers/net/sh_eth.c b/drivers/net/sh_eth.c index c1abe7c..0f6fdde 100644 --- a/drivers/net/sh_eth.c +++ b/drivers/net/sh_eth.c @@ -348,7 +348,7 @@ static int sh_eth_phy_config(struct sh_eth_dev *eth)

phydev = phy_connect( miiphy_get_dev_by_name(dev->name), - port_info->phy_addr, dev, PHY_INTERFACE_MODE_MII); + port_info->phy_addr, dev, CONFIG_SH_ETHER_PHY_MODE); port_info->phydev = phydev; phy_config(phydev);

@@ -405,6 +405,9 @@ static int sh_eth_config(struct sh_eth_dev *eth, bd_t *bd) outl(TPAUSER_UNLIMITED, TPAUSER(port)); #endif

+#if defined(CONFIG_CPU_SH7734) + outl(CONFIG_SH_ETHER_SH7734_MII, RMII_MII(port)); +#endif /* Configure phy */ ret = sh_eth_phy_config(eth); if (ret) { @@ -434,6 +437,12 @@ static int sh_eth_config(struct sh_eth_dev *eth, bd_t *bd) outl(0, RTRATE(port)); #endif } +#if defined(CONFIG_CPU_SH7763) || defined(CONFIG_CPU_SH7734) + else if (phy->speed == 1000) { + printf(SHETHER_NAME ": 1000Base/"); + outl(GECMR_1000B, GECMR(port)); + } +#endif

/* Check if full duplex mode is supported by the phy */ if (phy->duplex) { diff --git a/drivers/net/sh_eth.h b/drivers/net/sh_eth.h index 46d8b81..132ea7a 100644 --- a/drivers/net/sh_eth.h +++ b/drivers/net/sh_eth.h @@ -225,6 +225,7 @@ struct sh_eth_dev { #define GECMR(port) (BASE_IO_ADDR + 0x05b0) #define MAHR(port) (BASE_IO_ADDR + 0x05C0) #define MALR(port) (BASE_IO_ADDR + 0x05C8) +#define RMII_MII(port) (BASE_IO_ADDR + 0x0790)

#endif