Hi Marek,
On Thu, 25 Oct 2012 13:14:38 +0200, Marek Vasut marex@denx.de wrote:
Dear Fabio Estevam,
CCing Albert.
Hi Stefano,
On Thu, Oct 25, 2012 at 8:28 AM, Stefano Babic sbabic@denx.de wrote:
Yes, I thins is due to the fact that size for the framebuffer is allocated before relocation. This was also a reason for me to migrate to CONFIG_VIDEO instead of CONFIG_LCD.
mx53loco.h defines CONFIG_VIDEO, not CONFIG_LCD.
I am suspecting alignment/gcc issues: with a gcc4.4 I can boot into a prompt, but after typing any command and then "enter" the board crashes and reboot.
With gcc4.7, then board hangs after the total RAM is displayed.
Regards,
Fabio Estevam
The board should normally not hang but throw a data abort. In any case, try to run the board under a HW debugger to find out which exception occurs.
Best regards, Marek Vasut
Amicalement,