OK, Freescale engineers on/off the list should be able to help. This really shouldn't be hard.
I hope so :)
Running low on suggestions, but here goes...
- Fix the buswidth in the config file and then cycle power on everything
to make sure you have a clean new configuration (paranoia sometimes pays off)
What do you mean by "cycle power on everything" ?
The Abatron picks up its configuration file via TFTP (IIRC, otherwise FTP) from the host. You need to fix the file on the host so it has the x32 configuration. After fixing the file on the host, you need to reset/cycle power on the Abatron so it re-reads the config file, otherwise it will be using the old (wrong) config file.
Sometimes I forget <rolls eyes>. Major confusion ensues, followed by a facepalm moment. http://www.facepalm.org/
OK, I can understand what you meant ;)
- Verify the SIMM is x32.
Huh ? How ?
It's x32 unless I'm really confused.
Yes, I mean, how can I *verify* that it is x32 ?
Thx again. Regards JM