In message 43DB6042.9050000@mesias.co.uk you wrote:
Using the BDI probe and a fairly extensive config file (which sets up TLBs and LAWBARs) we are able to step through the programmed u-boot
I'd like to point out that this is NOT the recommended way of debug- ging U-Boot. It is usually much more efficient to use only a MINIMAL config file for the BDI2000.
although it has an alignment exception whilst running cpu/mpc85xx/start.S (at the part after the comment "Allocate Initial RAM in data cache"). We think it's an alignment exception because it jumps to the alignment exception handler address and continues briefly.
It can be anything - including a consequence of your inappropriate BDI config file.
I have a suspicion that we shouldn't be trying to single step this initialisation code after the BDI has set up the hardware somewhat. I
You shouldn't make the BDI initialize the HW in the first place.
have tried a reduced BDI config file and it still doesn't work, and it no longer single steps.
You have to work on the BDI init file until you can single-step U-Boot right from the reset entry point. As long as this doesn't work you cannot continue.
Best regards,
Wolfgang Denk