SCTLR is the abbreviation of System Control Register, so we should use SCTLR but not SCTRL.
Signed-off-by: Peng Fan Peng.Fan@freescale.com --- arch/arm/cpu/armv7/cpu.c | 2 +- arch/arm/cpu/armv7/start.S | 6 +++--- 2 files changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/arm/cpu/armv7/cpu.c b/arch/arm/cpu/armv7/cpu.c index 01cdb7e..c56417d 100644 --- a/arch/arm/cpu/armv7/cpu.c +++ b/arch/arm/cpu/armv7/cpu.c @@ -53,7 +53,7 @@ int cleanup_before_linux(void) * After D-cache is flushed and before it is disabled there may * be some new valid entries brought into the cache. We are sure * that these lines are not dirty and will not affect our execution. - * (because unwinding the call-stack and setting a bit in CP15 SCTRL + * (because unwinding the call-stack and setting a bit in CP15 SCTLR * is all we did during this. We have not pushed anything on to the * stack. Neither have we affected any static data) * So just invalidate the entire d-cache again to avoid coherency diff --git a/arch/arm/cpu/armv7/start.S b/arch/arm/cpu/armv7/start.S index fdc05b9..70048c1 100644 --- a/arch/arm/cpu/armv7/start.S +++ b/arch/arm/cpu/armv7/start.S @@ -52,10 +52,10 @@ reset: * Continue to use ROM code vector only in OMAP4 spl) */ #if !(defined(CONFIG_OMAP44XX) && defined(CONFIG_SPL_BUILD)) - /* Set V=0 in CP15 SCTRL register - for VBAR to point to vector */ - mrc p15, 0, r0, c1, c0, 0 @ Read CP15 SCTRL Register + /* Set V=0 in CP15 SCTLR register - for VBAR to point to vector */ + mrc p15, 0, r0, c1, c0, 0 @ Read CP15 SCTLR Register bic r0, #CR_V @ V = 0 - mcr p15, 0, r0, c1, c0, 0 @ Write CP15 SCTRL Register + mcr p15, 0, r0, c1, c0, 0 @ Write CP15 SCTLR Register
/* Set vector address in CP15 VBAR register */ ldr r0, =_start